I have a group which I stick to top of all pages. Works a treat. But on one page I have an alphabetic list where I put scroll locations for most of the letters.
The problem: The scroll location is now covered by the top group.
Is there an easy way of excluding only that page of the “stick to the top of page” ?
I know I could probably make a section for this page and a section for all the other pages (I have almost a hundred) which seems to me complicated.
Or is there a possibility to change the pixel position of all the 22 scroll locations in one go?
Any other - but please easier! - solution is highly appreciated!
I’m afraid there isn’t an easier solution right now…
Hello.
Unfortunately, this error description is very vague.
Is it the scroll location for the letter “A”?
Then leave it out and start with “B”.
To get to “A”, i.e. to the top of the page, use “Go to external link” and “#” without " as address. This will go to the same page at the top.
Mr. F.
1 Like
Thanks Mr. Fozzie for your suggestion. But …
The problem is that not all letters have the same amount of names, are the same length. So that doesn’t work. I was thinking of adding the pixel amount of the top group to each scroll location which should work, but is VERY cumbersome.
A scroll location aka “anchor” is not an element you will see in the layers panel.
Therefor you can not group (or move) it with something else.
You have to move them all by hand. And a bit of try and error is needed.
Mr. F.
1 Like